Metric DIN 427 Slotted Set Screws with Flat Point Specification Sheet

Metric DIN 427 Slotted Set Screws with Flat Point Specification Sheet

metric-din-427-slotted-set-screw-flat-point-specification

Metric DIN 427 Slotted Set Screws with Flat Point are typically used to secure one object within or against another. Since the set screw (aka grub screw) is headless and threaded along the entire length of the screw it can pass through a threaded hole of one object and tightened against another object. They are often used to prevent relative motion between two rotating parts such as the movement of a pulley or a gear on a shaft. The clamping force is generated through the bottom tip of the screw that projects through the outer object into or against the inner object. The flat point is a flat surface on the opposite end from the slotted drive and is the simplest and most economical type of set screw and is used for frequent repositioning of components where minimal shaft deformation is required. The slot drive allows for tightening and/or loosening with a single blade slotted screwdriver. Aspen Fasteners offers the following sizes for immediate delivery from stock: Diameters ranging from M3 to M10 and lengths up to 40mm in Steel and stainless steel A2 and A4. View available parts by clicking on the following link: DIN 427 Slotted Set Screws with Flat Point

To view the full specification and standard sheet with dimension, material, weight and mechanical properties click on the link at the top of page

This entry was posted in News, Product Insight and tagged , , , , , . Bookmark the permalink.

Leave a Reply

Your email address will not be published. Required fields are marked *

Spam protection by WP Captcha-Free