Metric DIN 965 Cross Recessed (Phillips) Flat Countersunk Machine Screws Specification pdf
Metric DIN 965 is a cross recessed (Phillips) flat countersunk machine screws. Metric machine screws are designed for metal to metal applications requiring a pre-drilled hole and a mating metric nut or the screw to thread into. These screws are usually fully threaded with machine threads and blunt point. The recommended pre-drilled hole sizes vary depending on the diameter of the screw to be used but should be slightly larger in diameter than the major (maximum) thread diameter. These screws are available in zinc plated steel as well as stainless steel A2 and A4. Metric Flat countersunk heads have a flat top surface and a cone-shaped bearing surface with a head angle of approximately 90°. They are used for applications where the head must be flush with the mating surface of the substrate. Aspen Fasteners offers over 500.000 unique fastener products from stock in inch and metric standard in a variety of materials and finishes. The following sizes metric DIN 965 cross recessed (Phillips) flat countersunk machine screws are available for immediate shipping from stock: Diameters ranging from M1.6 to M10up to 38mm long in zinc plated steel and stainless steel A2 and A4. View parts by clicking on the following link: DIN 965 cross recessed (Phillips) flat countersunk machine screws.
To view (or free download) the full specification and standard pdf sheet with dimension, material, weight, technical, chemical and mechanical properties click on the link at the top of page